Wire rope clips, also known as cable clamps or U-bolt clamps, are used to secure the ends of wire rope together to form a loop or to connect two sections of wire rope together. Here are the general steps for using wire rope clips:
Determine the number of clips required for the application. The number of clips required will depend on the diameter of the wire rope and the type of application. A general rule of thumb is to use three clips for wire ropes up to 1 inch in diameter, and four clips for wire ropes over 1 inch in diameter.
Place the first clip on the wire rope approximately one wire rope diameter from the end of the rope. The U-bolt portion of the clip should be placed on the dead end of the wire rope (i.e., the end that is not being used to form the loop).
Tighten the nuts on the U-bolt until the wire rope is snug against the saddle of the clip. Use a torque wrench to tighten the nuts to the manufacturer's recommended torque specifications.
Place the second clip on the wire rope approximately one wire rope diameter from the first clip, with the U-bolt portion of the clip on the live end of the wire rope (i.e., the end that is being used to form the loop).
Tighten the nuts on the U-bolt until the wire rope is snug against the saddle of the clip. Use a torque wrench to tighten the nuts to the manufacturer's recommended torque specifications.
If additional clips are required, repeat steps 4 and 5 until the required number of clips have been installed.
After all clips are installed, inspect the wire rope and clips for proper installation and any signs of wear or damage. It is important to regularly inspect wire rope clips to ensure they are secure and in good condition.
Note: It is important to follow the manufacturer's instructions and recommended procedures for the specific type of wire rope clip being used. Improper installation or use of wire rope clips can result in failure and serious injury.